DetailProduct

BOILER HOUSE EQUIPMENT Enquiry Form RV Details   The flash vessel is the main component in any flash recovery system. It can be used in all steam plants where high pressure condensate is reduced to a lower pressure, so that flash steam is formed by reevaporation. This steam can be used in low pressure process or […]

ADCATHERM HEAT EXCHANGERS Enquiry Form STS Details   The ADCA STS series steam to water shell and tube heat exchangers are shorter and lighter than the alternative shell and tube exchangers manufactured with smooth pipes. The use of extruded low fin tube has the advantage that it can improve the external surface and thermal performance. STH

PACKAGED UNITS/SKIDS Enquiry Form ECRU Details   The ADCAMAT ECRU series electric condensate recovery units are recommended in the transfer of high-temperature water such as hot condensate, to a higher elevation or pressure. This condensate is usually used as boiler feedwater. The standard models are prepared for flows up to 20 m3/h, or higher on request.

STEAM/WATER MIXERS Enquiry Form MX20 Details   The steam/water ADCAMix MX20 mixers provide a cheap and instantaneous source of low-pressure hot water, by using existing steam and cold water supplies. The mixer incorporates a safety device, to ensure that live steam cannot be accidentally ejected even if, for some reason, the cold water supply fails. SG20

STEAM INJECTORS Enquiry Form SI20 Details   The SI20 series steam injectors from ADCA are condensate injectors. They ensure low noise and vibration and rapid heating of still or flowing fluids in basins and vessels due to direct steam injection. SI115 Details   The SI series steam injectors from ADCA are condensate injectors. They ensure low noise

DIRECT STEAM HUMIDIFIERS Enquiry Form DSH Details   The ADCA DSH series of direct steam injection humidifiers are designed to ensure highly efficient and moisture free steam injection in air ducts and AHU for humidification purposes. These units are completely manufactured from corrosion resistant stainless steel, and are available as plug and play packaged solutions or

SAMPLE COOLERS Enquiry Form SC32-SC132 Details   The ADCA sample coolers are specially designed to cool samples of boiler water or steam for analysis. Sample coolers prevent steam flashing-off from hot pressurized liquid samples, which can be dangerous and may result in an incorrect sample. This device may be used for boiler water analysis and other

HUMIDITY SEPARATORS Enquiry Form SF251/S Details   The SF251/S series centrifugal separators remove moisture from steam and compressed air pipelines. Steam and compressed air pass through the separator and, as a result of centrifugal forces, impact and swirling effects, the particles with a heavier specific gravity, such as water and oil droplets, moisture in suspension, dirt

ADCAMAT PUMPS AND PUMP TRAPS Enquiry Form POP-LC Details   The ADCAMAT POP-LC (Pressure Operated Pump) is recommended in the transfer of high-temperature liquids such as condensate, oils and other liquids to a higher elevation or pressure. The pump starts when there is something to pump and stops when there isn’t. Under certain conditions, it can

STRAINERS Enquiry Form IS140 Details   The IS140 strainers are applicable to all types of steam, water, oil and air systems. Their purpose is to protect traps, regulating valves, piping, etc. from dirt and impurities, which are often the cause of damage and consequent energy loss of fluid systems. IS116 Details   The IS116 forged steel Y