DetailProduct

Gas Sampler Enquiry Form Details PTT’s Gas Sampler is a pumping system designed to draw gas samples from ducts or hard to access locations and deliver the samples to gas sensors such as the Toxic and Combustible Gas Detector that would be located in a more convenient area. The gas sampling systems use a high […]

 Combustible Gas Transmitter Enquiry Form Details PTT’s Combustible Gas Transmitter is a stand-alone gas transmitter designed to detect potentially hazardous concentrations of combustible gases in ambient air. Gases and hydrocarbon vapors such as methane, propane, butane, gasoline, toluene, hydrogen, and many others can be reliably monitored in process buildings, analyzer enclosures, pump stations, and gas

 Combustible Gas Detector Enquiry Form Details PTT’s Combustible Gas Detector system eliminates the need for frequent response checks with an automatic gas test every 24 hours. The result is a combustible gas detector system with a level of reliability beyond that of any other gas detector system available. This daily gas sensor response verification is

Wire Toxic Gas Transmitter Enquiry Form Details PTT’s  Wire UniSens universal 2-wire toxic gas transmitter handles 28 different gases, providing the most economical and flexible gas measurement system available today. Combining universal electronics, bench calibration capability, automatic sensor verification, fault detection and alarming, and superior sensor technology, UniSens is your best transmitter choice. UniSens is

 High Level Ammonia Gas Detector Enquiry Form Details The Infrared Gas Detector is a rugged reliable microprocessor based intelligent gas detector. The can be used to monitor from PPM levels to explosive levels of ammonia gas. This ideally suited for use in harsh environments where electrochemical sensor life can be short. Areas such as engine

GAS Sampling System Enquiry Form Details Monitoring combustible or toxic gases in areas with condensing levels of moisture often results in premature sensor failure. Water condensing on sensor surfaces or within the sensor flame arrestor can be difficult to avoid due to widely variable ambient conditions. PTT has developed a solution to this problem with

 Wet Gas Detector Enquiry Form Details Increasingly stringent air quality requirements have led to expanded use of wet scrubber systems to control pollutant gases released as air emissions. Chlorine storage facilities and chemical process plants are frequently required to scrub exhaust gas streams to remove halogen and acid gases. Unfortunately, monitoring reactive gas concentrations in

Gas Alarm Module Enquiry Form Details PTT’s Gas Alarm Module Receivers are compact electronic modules that provide local alarm, display, and signal retransmission functions for gas detection systems. The modules are designed to accept input from either two, three, or four wire 4-20 mA transmitters located up to 10,000 feet from the receiver. They’re ideally

Wire Gas Transmitter Enquiry Form Details Transmitters are loop-powered instruments that transmit a 4-20 mA signal linearly proportional to gas concentration. Operated from a 24 VDC power supply, the transmitter will drive loads up to 675 ohms, sufficient for most monitoring applications. Alternatively, the unit can operate at 12 VDC with reduced output load for

 Wet H2S Gas Detector Enquiry Form Details Odor control in wastewater treatment plants and sewage collection systems often requires the use of scrubber systems. Many of these scrubbers employ a wet process using a hypochlorite solution to remove hydrogen sulfide (H2S) from air streams prior to discharge. Monitoring the hydrogen sulfide in both inlet and